Clean if necessary press the small diagnostic button next to the display for 3 seconds to stop.
Hayward aqua rite salt chlorine generator troubleshooting.
Check salt inspect cell.
The hayward aqua rite has sensed a no flow condition and has stopped generating chlorine.
Using information provided by hayward pool we have created the following troubleshooting guide to help pool owners understand the diagnostic codes and quickly restore their hayward aqua rite salt chlorination system.
Flashing or on 1.
Flashing or on when these lights flash the cell reports salt levels between 2400 2700ppm.
Aquarite turns salt into chlorine eliminating red eyes itchy skin harsh odors.
Aquarite the world s 1 salt chlorinator delivers soft silky water.
Solutions for pools up to 40 000 gallons.
Hayward aqua rite troubleshooting guide.
If you re reading this blog that means you need help troubleshooting your hayward aqua rite salt system.
Before operation the aqua rite must be configured for the chlorinator cell that will be used.
If the incorrect cell is chosen the salt level amperage and voltage will not be correct and the system will turn the chlorinator off.
If the check salt inspect cell leds cleared then the problem is solved.
If the incorrect cell is chosen the salt level will be inaccurate and the system will likely suspend chlorination as a result.
The flashing inspect cell led and start the timer for the next 500 hours.
Just like any other salt chlorine generator the aqua rite may need a quick tune up from time to time.
T is the factory default.
Slide the main switch to the auto position.
But you know what s not great.
The hayward aqua rite salt chlorine generator is hands down the most popular residential salt chlorinator in the pool industry.
Well the good news is you are at the right spot and you re definitely not alone.
T 15 is the factory default.
After you inspect the cell and.
The aqua rite electrolytic cell has a self cleaning feature incorporated into the electronic control s.
This does not affect chlorine production.
Make sure you have at least 12 of straight pipe before the flow switch.
Replace the cell with the same model as it had prior and then reset the average salt level instructions on pg.
Flashing or on cont 18 the cell needs to be replaced in order for the aquarite control center to read the salt level accurately.
Check salt inspect cell.
Troubleshooting and diagnosing their problems.
Check that the flow switch is plugged into the connector on the bottom of the control unit and that the wire is not cut or damaged.
Before operation the aquarite must be configured to the correct turbocell installed.
