This part is used to keep the clothes inside the tub during the wash cycle.
Frigidaire front load washer door boot seal.
The last step was to re attach the boot with the spring.
The folds in the bellow allow the tub to move separately from the door during the spin cycle.
Frigidaire kenmore crosley gibson westinghouse electrolux.
Sealpro 134515300 5304505240 wh45x10075 washer door bellow seal compatible for frigidaire made by oem manufacturer 134365200 137566001 137566000 5304450475 ap3869103 ps1148773 1 year warranty 4 5 out of 5 stars 68.
Also known as a door boot seal and is used in front load washers.
Remove the 2 zip ties hoses and light from the top.
This part has been redesigned by the manufacturer and is interchangeable with the old design.
My washer is an electrolux front load but the same part with 2 hoses and a light at the top.
Dry the washer thoroughly with clean shop towels especially the areas around and underneath the door gasket.
We used dish washing liquid to lubricate the boot as recommended.
The machine appears to be operating normally and there are no leaks.
The only way to deal with the problem of mold on the rubber seal of front load washer is to clean it regularly using the steps below.
We recently replaced the agitator basket on our machine purchased in 1999.
This part is used to keep the clothes inside the tub during the wash cycle.
Also known as a door boot seal and is used in front load washers.
Get shopping advice from experts friends and the community.
All of the information in this seal replacement video is applicable to the following brands.
Pull the seal away from the washer front panel.
Water is often trapped in the rubber gasket around the door and over time this leads to the growth of mold.
7 leave the washing machine door open for at least 30 minutes after treating it for mold.
Remove the outer spring clamp ring using the needle nose pliers.
Kenmore 417 series front loading washer.
Push the seal inside the drum.
The folds in the bellow allow the tub to move separately from the door during the spin cycle.
The most common reason for replacing the door boot seal is if it is torn or ripped causing the washer to leak water.