Framing New Roof Over Existing Roof

This new roof with a higher pitch can be accomplished with premade roof trusses and typical asphalt shingles.

Framing new roof over existing roof.

The roof sheathing on the old roof is not rotten just not up to the standards my dh thinks it should be. Fold new shingles over the new valley onto the old roof overlapping by at least a foot. We aren t planning on going up a floor so the roof would only be marginally higher than it is now. The roof is erected over a deck that will be screened as an outdoor living area.

Roofing over your existing roof is not always possible. Then nail shingles on the new roof and exposed areas of the old roof. We are planning to frame the new roof over the existing roof. Finish the new roof by nailing on osb sheathing covering it with roofing paper and nailing in metal flashing along the valleys and metal drip edge at the eaves.

If you are building a new home putting an addition on an existing home or replacing your roof down to the rafters you will need a new roof frame. Sounds simple enough right. There are a few situations where roofing over an existing roof just isn t possible. Unfortunately it s not an option for everyone.

The old shingles are visible inside the framing of the new roof. Installing a new roof over an existing one also called a layover or nailover is often possible although not always the best option a properly installed layover roof can look and function as well. The exposed edges of the 3 layers of rigid insulation are no longer exposed. Box beam gable framing new gable overhang is framed in the form of a box beam hanging off of a new layer of roof plywood roof sheathing cantilevered over the top of the 3 layers of rigid insulation.

The new ridge will tie into the existing roof as a hip and valley offshoot. Dh is a very skilled carpenter and is confident that he can do this work. Metal roofing materials are available in several styles that require different fastening applications but are most commonly screwed to the roof framing or sheathing material. Lay a metal roofing panel over the existing roof material in the bottom corner of the roof surface and fasten to the roof according to the metal panel instructions.

Replacing a roof can be expensive but if a roof contains only a small slope it s possible to raise the roof pitch of a house by building a roof over the old one. When you recover your old roof stays and the new roof gets installed on top.