Ford F250 Track Bar Ball Joint Removal

Turn the forcing screw until it meets the ball joint.

Ford f250 track bar ball joint removal.

Acdelco 45d2395 professional front at track bar suspension ball joint assembly. Repeat steps 3 4 to remove the upper ball joint. Best place to get the ball joint i found was rock auto. Tighten the forcing screw until the ball joint is removed.

4 6 out of 5 stars 70. I bought one at harbor freight and it worked fine. Remove the upper and lower ball joint nuts. 4 4 out of 5 stars 63.

You will need access to a press drill torque wrench and a ball joint press if replacing the ball joint. Track bar bracket nut goes on at 406 ft lb. Get it as soon as fri sep 18. Assemble the ball joint press over the ball joint as shown in figure 1.

Just tightened it the tapped the end with a hammer and repeated till it popped. With a suitable press remove the old bushing from the track bar. Blain the tools for an 06 to do this job would be. Reinstall the knuckle into the housing and loosely install the nuts on the ball joints.

I got this info out of the 2006 super duty works shop manual. Removing an upper ball joint with a hammer. This looks to be a normal ball joint tool set. Knock each ball joint out of the housing and remove the knuckle.

Enjoy the videos and music you love upload original content and share it all with friends family and the world on youtube. Check the alignment of all components. Remove the lower ball joint snap ring if applicable. Remove the track bar from the truck per ford service procedure.

Use a ball joint press to install new ball joints. The third kit doesn t include the drill bit or the ball joint. Tighten each to manufacturer specs. 204 355 remover installer ball joint.

It s definitely a pia but a 4x4 ball joint press it comes right. 205 086 t74p 4635 c c frame and screw. I changed mine out when i upgraded to icons track bar. Remove the snap ring from the lower ball joint.

Remove the old ball joints with a press or a hammer.